Optimum Gloss Coat
Optimum Gloss-Coat is the most advanced polymer system that forms a layer of clear coat over the automotive finishes. Optimum Gloss-Coat provides better scratch and mar resistance, better UV resistance, better chemical etch resistance, and has better release properties than any other consumer product while providing unsurpassed gloss and slickness. Additionally, you can top Optimum Gloss-Coat with any non-abrasive wax or sealant of your choice to add additional gloss and slickness.
Optimum Gloss-Coat can be used to protect the following surfaces:
- Painted Surfaces
- Plastic trim
- Aluminium & chrome surfaces
Optimum Gloss-Coat is an additional barrier between the elements and your vehicle's paint. The paint will retain its color and contaminants will be blocked out to keep the paint smooth and clean. Unlike waxes and paint sealants that require frequent reapplication, Optimum Gloss-Coat provides constant, unyielding protection for up to two years!
Because Optimum Gloss-Coat is semi-permanent, the paint finish has to be properly prepared before applying it. Any blemishes or contamination on the paint will be locked in so remove them first! On a properly prepared paint finish, Optimum Gloss-Coat will look clear, smooth, and clean.
Once Optimum Gloss-Coat cures, washing is the only maintenance needed to keep your vehicle looking fantastic. The coating can be clayed but it should not be necessary since Gloss-Coat releases contaminants easily. Use detail sprays as desired to intensify the gloss. You can top the coating with your favorite non-abrasive wax or sealant if you desire.
- Polish paint with Optimum Polish II or Optimum Hyper Polish to remove any defects.
- Clean surface with 15% IPA solution to remove all polishing oils, waxes, and silicones.
- Prime the applicator by making an X pattern across the pad. Only a few drops will be needed for each subsequent panel.
- Wipe Optimum Gloss-Coat onto a single panel at a time in a thin layer using two directions, in a circular or front to back direction.
- Within 5 minutes, inspect the panel with adequate lighting looking for any thick areas that have not flashed away to clear.
- Use foam applicator or paint safe microfiber to even out any areas where you see streaks. This step is key, as any spots not leveled will have to be polished if allowed to cure. Panels will feel a bit tacky and will be self-leveling during cure time, so avoid any unnecessary touching, wiping, or contact to produce the best results.
- Repeat steps 1-6 for each panel where application is desired.